L Series

UL Recognized
CSA Certified
VDE Approved

Catalog Data Sheet

L Series

The L series power entry modules are compact units that combine a multi-function power entry module and high performance RFI filtering capabilities. They are available with either a four-voltage selector or a DPST on/off switch. Both variations can be specified with North American or European fusing capabilities and are available in either flange or snap-in mounting.

These filters are UL recognized, CSA certified, and VDE approved. The L series modules offer a choice of filters for general or medical applications.

EDL Models

The RFI filter is for general purpose applications where line-to-line and line-to-ground noise must be controlled. The filter is designed to meet the very low leakage requirements of VDE portable equipment. They are available in three current ratings.

EHL Models

This medical filter provides susceptibility protection without the leakage current associated with line-to-ground capacitors. Designed to allow equipment to meet UL544 for patient care and non-patient care equipment, the EHL filter has a maximum leakage current of 2 μA at 120 VAC 60 Hz.

See Appendix C for more information on UL544 or UL2601 health care applications.

Note: When using the models with an IEC connector, remember that the leakage current of the companion line cord, GA400, is more significant than that of the filter - which may disqualify this line cord from use in patient care applications.

Electrical Schematic

EL Models (with Switch)

click on image for larger view

DL Models (with 4-voltage selection)

click on image for larger view

HL Models (with Switch

click on image for larger view

HL Models (with 4-voltage selection)

click on image for larger view

Note 1: Provisioni for dual European style fusing
Note 2: On/ Off switch present only with "S" suffix

Resistor location for reference only

Specifications

Voltage Selection

To change selected voltage: disconnect the power cord; open cover using a small blade screwdriver or similar tool; insert the tool into the voltage selection slot and remove wheel from unit; select desired voltage; replace wheel into unit and close cover, making sure the selected voltage appears in connector window.

Click on image for larger version

Note: All models have North American or dual European fusing capability and are available in either flange or snap-in mounting.

Case Styles - Unfiltered

Unfiltered Flange Models

Unfiltered Snap-In Models

Case Styles - Filtered

Filtered Flange Models

Filtered Snap-In Models

3

Case Dimensions

Part Numbers

Click on any part number for distributor stock status and eCommerce Links. For more information refer to the Corcom Part Numbering System reference.